Instructions:

1) Drain the water from the breeding zone as specified by your Mosquito Preventer's User Manual.

2) Turn off your Mosquito Preventer (Automatic Preventer only)

3) Open the latches at the sides of your Preventer and remove the Preventer's top portion. 

3) Fill the bottom reservoir of your Preventer with non-chlorinated or distilled water. For optimal results use rain water, which can be collected from a rain barrel. 

4) Open and empty the provided mosquito lure into the Preventer's bottom reservoir. If switching which type of lure you are using follow the carefully provided instructions within your user manual.

5) Unscrew old filter and place it within a resealable bag. Install the new filter by simply screwing it into the the old filter's previous location, ensuring that it is properly fastened.

6) Carefully remove the old landing strips from the top of your Preventer and place them in the same bag as the old filter. Open and remove the new landing strips from their package and place them in the pre-existing landing strip area. 

7) Properly dispose of the bag containing the old filter and landing strips making sure to avoid moist/wet areas.

8) Replace the top portion of your Preventer, ensuring that each half is properly aligned. Close the side latches.

9) Automatic Preventer: Turn your preventer back on and start the cycle 

      Manual Preventer: Refill the breeding reservoir asspecified in your Mosquito Preventer's User Manual.